Novell ZENworks Endpoint Security Management 3.5 Uživatelský manuál stáhnout pdf (Strana 110)

ZENworks® ESM 3.5 Administrator’s Manual 110

Communication Hardware Settings

Communication hardware controls by location which hardware types are permitted a connection

within this network environment. As it was previously determined whether to globally enable or

disable each setting, the default selection: Apply Global Setting will maintain the default setting

for the device. The default may be optionally enabled or disabled at this location, overriding the

global setting.

To access this control, open the Locations tab and click the Comm Hardware icon in the policy

tree on the left.

Figure 81 : Location Communication Hardware Control

Select to either enable, disable, or apply the global setting for each communication hardware

device listed:

• IrDA® (Infrared Data Association) - controls the infrared access port on the endpoint

• Bluetooth® - controls the Bluetooth® access port on the endpoint

• 1394 (FireWire™) - controls the FireWire™ access port on the endpoint

• Serial/Parallel - controls serial and parallel port access on the endpoint

• Dialup - controls modem connectivity by location - not given a global setting

• Wired - controls LAN card connectivity by location - not given a global setting

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 244 245

Žádné komentáře

Novell ZENworks Endpoint Security Management 3.5 Uživatelský manuál Strana 110